Calibration Link Input

Navigation:  Widget Designer > Nodes > Input Nodes > Devices Input >

Calibration Link Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Devices Input >

Calibration Link Input

prev main next


The Calibration Link Input node allows to communicate with the Calibration Link or a NET Link equipped with fiber input boards. Please see more information in the chapter covering the NET Link.
On the one hand the node receives information send from the 16 fiber inputs, hence, it provides this data to other nodes in Widget Designer. On the other hand, it allows to configure the device and send commands to it.

The NET Link Input node, the Relay Output node and the tool "Projector Calibration Manager" might also be of interest for you.

This node can be found under Nodes > Input > Devices > Calibration Link


Node properties

IP and Port:
Enter the correct IP address and port from the NET Link's processor or from the Calibration Link.

Select Adapter:

Specify here the NIC you want to use for communication with the NET Link.

Reset To Factory Default:
This buttons resets the above settings in the Widget Designer interface. To reset the device itself (to the IP address and the port to 5000), hold the "Reset" button down whilst plugging the power into the device. Release the button again.

Connect / Disconnect:
Before starting to communicate with the device, for instance receive data, the node must be connected to the device. The connection itself consumes no performance.

Change IP Address:
This button opens a new dialog whereto you may enter another IP address and port for the device. Power-cycle the device to apply the changes.

Config Module:
A NET Link / Calibration Link is configured by us as you have ordered it. However, if you have changed some input / output boards, the processor must be configured in terms of giving him the information which boards are connected to it. Click the "Config Module" button to open a new dialog where you may choose the according boards per processor connection. Find more details in the NET Link hardware chapter.

Start Data, Start Integrate and Stop Data:
As soon as data is processed via the network from the device to Widget Designer, performance is drawn. For normal use, click "Start Data" (sets a high data rate). For the use of measuring the light distribution over a longer time period, activate the slower data rate with "Start Integrate".

Store Last Transmission State to NET Link CPU:
Click this button and power-cycle the device if you wish that it remembers whether it should (not) send data as soon as it is powered up.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "Node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255) colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

In addition to the general commands, this nodes provides specific function commands that can replace pressing the buttons in the Configuration manually. E.g. Node1.StartDate starts data transmission without opening the dialog.

The following additional function commands are available for the Calibration Link node:

- ChangeIP
- Connect
- Disconnect
- getconfig
- SetConfig
- StartData
- StartIntegrate
- StopData
- StoreLastTxMode
- Tx3

Node output values

The node generates the following output:

- Value 1 to 16 (0 - 1023)
- Connected