Please wait. Due to its content this page might take a while to load...

This chapter describes how to change or link parameter values in the Device Control tab.

The parameter values are shown in decimal readout and centered by default. To display them in percentage readout and/or non-centered, please have a look in the Configuration tab > Devices / Parameters.

Changing Parameter Values

You can change a parameter in the Device Control tab or in the Device Tree, as described here. All changes made to the parameter values will turn the parameter active and red (until it is stored in the Sequence).

If there is a fader for the parameter, you have the following possibilities to change the parameters value:

-Use the fader handle for coarse control

-Click the fader once and use the arrow keys [Up] or [Down] => +1 / -1 steps; hold [Ctrl] too => +10 / -10 steps.

-Click in the numeric value field above the fader and drag it up / down for sharp tuning.

-Click the arrow buttons next to the numeric value field for finest control.

-Enter the new value manually into the numeric value field (double-click first) and press [Enter] to apply the change.

-Press the "Reset" button to set the parameter back to its default value. The status "active" will be removed from the parameter.

 

If there is only a numeric value field for the parameter, you have the following possibilities to change the parameters value:

-Click in the numeric value field and drag it up / down for sharp tuning.

-Click the arrow buttons next to the numeric value field for finest control.

-Enter the new value manually into the numeric value field (double-click first) and press [Enter] to apply the change.

-Press the "R" (for reset) button to set the parameter back to its default value. The status "active" will be removed from the parameter.

Linking Parameters