COM Stream Input

Navigation:  Widget Designer > Nodes > Input Nodes > Connections Input >

COM Stream Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Connections Input >

COM Stream Input

prev main next

Please wait. Due to its content this page might take a while to load...

The Com ASCII Stream input node allows receiving ASCII values over a local COM Port connection. The COM Port connection needs to be enabled in the Connection Manager.
This input node can output by default any incoming packet as text if no ASCII filter is applied.

This node can be found under Nodes > Input > Connections > COM Stream Input

wd_nodes_input_com-stream-in

Node Properties

COM Connection ID:
Enter the ID of the COM Port connection.

Message:
The received message between Start [STX] and End [ETX] symbol is displayed here.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Stream Message as String