Please wait. Due to its content this page might take a while to load...
The section "SMPTE Time Code" in the Local category from the Configuration tab allows to assign the Sequence faders and Cue buttons for the Christie Jog/Shuttle and Fader Extension. Without assigning them here, the controller boards will not work.
Press this button if the connected controller board is not shown in the tab. This will reload the connection.
- Enable Sequence On/Off Key
This option is valid for the former Jog/Shuttle Controllers. The Sequence On/Off Key is enabled by default. This button will toggle the opacity of the selected sequence between 0% and 100%. This option may be disabled so that the sequence cannot be turned off by fault.
- Load Selected Sequence
When this option is enabled, the sequence selected by the sequence faders will be active and loaded into the Sequence Tab.
- Enable Jog/Shuttle / Fader Extension
Both check boxes en- or disable the communication with the connected controller boards.
- Sequence ID
- Cue IDs
If there is a Fader Extension Board attached to the Pandoras Box Master as well, six additional faders and Sequence IDs are shown. Assigning sequences to faders and cues to buttons works in the same way as explained above.