If Filter

Navigation:  Widget Designer > Nodes > Filter Nodes >

If Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes >

If Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The IF filter node allows comparing incoming data. It can output specific values if the statement is true or false, or simply the state as 1 and 0.

The node can be found under Nodes > Filter Nodes > If

wd_nodes_filter_if

Node Properties

A:
Choose an input node from the drop-down or enter a numeric value or text.

Operator:
Choose the Operator.

B:
Choose an input node from the drop-down or enter a numeric value or text.

True:
If the operation is True, the selected input node value or entered value will be given out as Output Value.

False:
If the operation is False, the selected input node value or entered value will be given out as Output Value.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Output Value
- Output State (1 = True, 0 = False)