Please wait. Due to its content this page might take a while to load...
The Midi input node allows receiving 7bit or 15bit input values as well as Note On/Off and raw byte messages.
The Midi connection needs to be enabled in the Connection Manager.
This node can be found under Nodes > Input > Connections > Midi Input
Enter here the ID of your Midi Input device as assigned at the Midi Connection Manager.
Add the Status, Channel and Note value.
Choose between 7bit or 15bit input values.
With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).
Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).
The Node generates the following output:
- Current Value
- Status Byte
- Channel Byte
- DataByte 1 to DataByte 3