Multi-Touch Item Input

Navigation:  Widget Designer > Nodes > Input Nodes > Widgets Input >

Multi-Touch Item Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Widgets Input >

Multi-Touch Item Input

prev main next

Please wait. Due to its content this page might take a while to load...

The Multi-Touch Item input node provides the current state of a Multi-Touch Item (Position, Rotation, Size) as well as the current state of the Layer in PB linked to this Item. See the Multitouch Tool for further information and setup.

The node can be found under Nodes > Input Nodes > Widgets > Multi-Touch Item Input

Or by right-clicking on the respective widget itself and selecting Create related Node > Multi-Touch Item Input

wd_nodes_input_multi-touch-item

Node Properties

Panel ID:
Enter the ID of the Multi-Touch Panel.

Item ID:
Enter the ID of the Multi-Touch Item you want to use.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The node generates the following output:

 
- X Pos %
- Y Pos %
- Z Rot °

- X Size %

- Y Size %

- X Size %

- X Pos PB

- Y Pos PB

- Z Rot PB

- X Size PB

- Y Size PB

- X Size PB