Multi-Touch Point Input

Navigation:  Widget Designer > Nodes > Input Nodes > Widgets Input >

Multi-Touch Point Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Widgets Input >

Multi-Touch Point Input

prev main next

Please wait. Due to its content this page might take a while to load...

The Multi-Touch Point input node provides the current Position of a touch point inside a Multi-Touch Panel. See the Multitouch Tool for further information and setup.

The node can be found under Nodes > Input Nodes > Widgets > Multi-Touch Point Input

Or by right-clicking on the respective widget itself and selecting Create related Node > Multi-Touch Point Input

wd_nodes_input_multi-touch-point

Node Properties

Panel ID:
Enter the ID of the Multi-Touch Panel.

Point ID:
Enter the ID of the Multi-Touch Point you want to use.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The node generates the following output:

- X Pos

- Y Pos

- Active