Please wait. Due to its content this page might take a while to load...

The Normalize Filter node normalizes the incoming value. The input is mapped on a value between 0 and 1, where Min represents the value mapped on 0 and Max represents the value mapped on 1.

Values outside the range of Min and Max will be normalized with modulo(input/(Max-Min)), normalizations of values smaller than Min will have a negative sign.

The node can be found under Nodes > Filter Nodes > Math > Normalize

## Node properties

### Input:

Choose an input node from the drop-down or enter a numeric value.

### Min:

Enter the numeric value that should be mapped to 0.

### Max:

Enter the numeric value that should be mapped to 1.

## Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.

In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

## Node output values

The Node generates the following output:

- Result