Patch Settings

Navigation:  Tools and Other Software > Matrix Patcher > Matrix Patcher User Interface >

Patch Settings

prev main next

Navigation:  Tools and Other Software > Matrix Patcher > Matrix Patcher User Interface >

Patch Settings

prev main next

Please wait. Due to its content this page might take a while to load...

The section "Patch settings" of the Matrix Patcher allows to change the Patch size and how it is displayed. For other sections of the user interface see the introductory chapter.

matrix-patcher_patch-settings-menuZoom

By default the zoom factor is set to 1. Increase the value to zoom into the patch, decrease it to zoom out.

Center

Press [Center] to move the patch's center point into the center of the user interface. This can be helpful after dragging the patch.

Patch Size

This simply displays the current pixel size of the patch. To edit it, open the Edit menu and choose "Resize Patch."

Show Pixel Grid

Check this option if you like to see a pixel grid in the patch. Note that the Zoom factor should be above 1.

Show BG

A background image (for example a floor plan) may be displayed in patch. To load a background image, open the Edit Menu and choose "Load BG image".

Show Info

When enabling this option, one of the following information will be shown on the patch for each fixture.
- Patch, i.e. DMX Addressing
- Lan IP-address
- ID
- Size [%] or
- Rotation Angle [°]

Transparent Fixture

Enable this option  to display all fixtures half transparent.