Please wait. Due to its content this page might take a while to load...
The tab is hidden in the basic mode. To activate the advanced mode, open the "Edit" menu and choose "Advanced Mode". This is only available in the Warper 3D edition.
First of all, choose the camera from the Warper from which you would like to transfer data. Once you have picked a camera via the drop-down list at the top right of the Toolbox, make sure that the settings in the tab "Camera / View" are correct. Now set up the connection to a Pandoras Box Master system (PB) via Edit > Network Settings.
Click the "Enable" check box to send values permanently from the Camera / View tab to the Output or Camera layer in PB. The site and layer ID can be set up with the numeric boxes. The interval can be adjusted with the numeric box at the bottom.
If you do not want to update the layer permanently you may click the button "Update Camera" instead. This will transfer the current values only once. As an alternative, you may press [Ctrl + U].
If you like to transfer the values to a Light Layer, click the button "Update Light".