Please wait. Due to its content this page might take a while to load...
The Layer Mouse Input node provides mouse and single touch point feedback from a Pandoras Box system with activated "Input Events". In difference to the Layer Interaction node, this node can filter data based on the Site or Device ID whilst the Layer Touch input works with multi-touch input.
The node can be found under Nodes > Input Nodes > Pandoras Box > Layer Mouse Input
The chapter "Picking Mode" explains what to set up on Pandoras Box side but also in Widget Designer.
- PB Master or Client > Input Event Settings > "Output" and "Widget Designer Device" activated
- PB Master in Picking Mode or Client connected to mouse or touch device
- WD > PB Network Configuration > connected to Master and "Enable Connections" to Widget Designer Device => "Input Tester"shows data
If you are interested in sending mouse or touch data to a Pandoras Box (drawing) Canvas, please see the chapter "Layer UV Draw to Canvas".
Optionally, enter the IP from the Pandoras Box Master, otherwise the Master connection from the PB Network Configuration works.
Enter a Site ID from Pandoras Box, see "Filter". and optionally also a Device ID from Pandoras Box and change below option "Filter" if you like to filter the incoming data to receive only data depending on the Site and optionally also the Device.
Enter a Device ID from Pandoras Box, see "Filter".
Set the Filter option to "Site" in case you like to process only the input data sent by the Site ID entered above.
Set the Filter to "Site Device" if you like to filter incoming data even more, that is to receive only feedback from the Site and Device ID entered above.
If the Filter is set to "Any" you will see unfiltered data from all Sites and Devices.
With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).
Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).connected