PB Device Parameter Input

Navigation:  Widget Designer > Nodes > Input Nodes > Pandoras Box Input >

PB Device Parameter Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Pandoras Box Input >

PB Device Parameter Input

prev main next

Please wait. Due to its content this page might take a while to load...

The PB Device Parameter input node provides feedback values for all layer parameters from a Pandoras Box Master and Backup System for further processing.

The node can be found under Nodes > Input Nodes > Pandoras Box > Device Parameter

wd_nodes_input_device-parameter

Node Properties

Site ID:
Enter the Site ID from which you want to get feedback values.

Device ID:
Enter the Device ID from which you want to get feedback values.

Parameter:
Choose the parameter you want to monitor from the drop-down.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

 

- PB Device Parameter Input Value

- PB Device Parameter Input Backup Value

Example:
To route the current value of the parameter X Position of layer 1.3 to another node, enter "1" as SiteID, "3" as DeviceID and choose "X Position" from the drop-down list.

The PB Master and Backup Connection needs to be set up in the PB Configuration first!