PB Sequence Control Output

Navigation:  Widget Designer > Nodes > Output Nodes > Pandoras Box Output >

PB Sequence Control Output

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Pandoras Box Output >

PB Sequence Control Output

prev main next

Please wait. Due to its content this page might take a while to load...

The Sequence Control output node allows mapping any input or filter node data to any sequence parameter value.

This node can be found under Nodes > Output > Pandoras Box > Sequence Control

wd_nodes_output_sequence-control

Node Properties

Sequence ID:
Enter the Sequence ID.

Parameter:
Enable all parameters you want to control by ticking its check box. Choose the input source for the parameter from the list.
The parameters accept different value ranges:

Opacity

0 to 255

Play, Pause, Stop

0=false, 1=true

GotoCue

Cue ID

Next/Last Cue and Next / Last Frame

0=false, 1=true

 

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).