PB Sequence Seek Output

Navigation:  Widget Designer > Nodes > Output Nodes > Pandoras Box Output >

PB Sequence Seek Output

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Pandoras Box Output >

PB Sequence Seek Output

prev main next

Please wait. Due to its content this page might take a while to load...

The Sequence Seek output node allows mapping any input or filter node data in order to set any sequence to any timecode.

This node can be found under Nodes > Output > Pandoras Box > Sequence Seek

wd_nodes_output_sequence-seek

Node Properties

Sequence ID:
Enter the Sequence ID.

Hours:
Choose the input source from the list.

Minutes:
Choose the input source from the list.

Seconds:
Choose the input source from the list.

Frames:
Choose the input source from the list.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).