Range Filter

Navigation:  Widget Designer > Nodes > Filter Nodes >

Range Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes >

Range Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The Range filter node allows mapping any input range to a new output range. You may set limits, otherwise if the input range is exceeded in both, positive or negative values, the conversion will still be applied.

The node can be found under Nodes > Filter Nodes > Range

wd_nodes_filter_range

Node Properties

Input:
Choose an input node from the drop-down or enter a numeric value.

Input Min:
Enter the Input Minimum value.

Input Max:
Enter the Input Maximum value.

Output Min:
Enter the Output Minimum value. The Input Minimum value will be mapped to the Output Minimum value.

Output Max:
Enter the Output Minimum value. The Input Maximum value will be mapped to the Output Maximum value.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Output