RSS Input

Navigation:  Widget Designer > Nodes > Input Nodes > Tools Input >

RSS Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Tools Input >

RSS Input

prev main next

Please wait. Due to its content this page might take a while to load...

The RSS input node provides all incoming RSS feeds for further processing.
Please setup the RSS connection in the RSS Settings before.

The node can be found under Nodes > Input Nodes > Tools > RSS

wd_nodes_input_rss

Node Properties

Start Index:
Enter the Index of the RSS Feed where the cycling should start. This will affect the outputs Current RSS and Current ID.

Interval (seconds):
All incoming RSS Feeds will be cycling in the entered amount of time. This will affect the outputs Current RSS and Current ID.

Single Index:
Enter the Index of the RSS Feed that you want to route to the output Single RSS.

Filter By RSS ID:

As you can receive several RSS feeds at once, you can limit the messages displayed by this node to one single Feed. Check this box and enter the respective RSS ID.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

 
- RSS Count
- Last RSS
- Current RSS
- Current ID
- Single RSS
- RND RSS

- Last Title

- Last Text

- Current Title

- Current Text

- Single Title

- Single Text

- RND Title

- RND Text