SMPTE Link Input

Navigation:  Widget Designer > Nodes > Input Nodes > Connections Input >

SMPTE Link Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Connections Input >

SMPTE Link Input

prev main next

Please wait. Due to its content this page might take a while to load...

The SMPTE Link input node allows reading and using timecode within Widget Designer.
The SMPTE connection needs to be enabled in the Connection Manager.

This node can be found under Nodes > Input > Connections > SMPTE Link

wd_nodes_input_smpte-link

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Hours

- Minutes

- Seconds

- Frames

- FPS

- Drop Frames