Please wait. Due to its content this page might take a while to load...
From one unit there can be used simultaneously:
Since the SensorLink is based on TCP/IP communication (outputs TCP/IP at variable frequency between 50 and 5000 Hz), multiple units can be used at the same time.
The internal sample rate reads incoming data at 7 kHz to allow high resolution encoder inputs to be used for accurate motion sensing.
The front panel shows the Neutrik Ethernet input jack as well as the 4 pin XLR 12V power input.
As the unit can be programmed for various encoder step count settings or remote rest indexing a reset button is provided to restore the factory settings of the unit.
Three status LEDs give feedback information of the current state of the unit.