UDP ASCII Stream Output

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

UDP ASCII Stream Output

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

UDP ASCII Stream Output

prev main next

Please wait. Due to its content this page might take a while to load...

The UDP ASCII Stream output node allows sending ASCII values over an UDP connection.

Set up the UDP Connection in the Connection Manager.

This node can be found under Nodes > Output > Connections > UDP ASCII Stream

wd_nodes_output_udp-ascii-stream

Node Properties

TCP Connection ID:
Enter the UDP Connection ID.

Start and Stop Bytes:
Enter Start and Stop Bytes that should frame the message.
Enter these values as string, dec or hex value. Please refer to Syntax TCP- / UDP- / Serial messages.

Input Message:
Please select the input node source that should be given out via this UDP output node from the drop-down.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).